Effect of Disc Plough Tilt Angle on Stress Distribution Based on Pareto Multi-Objective Optimization
Keywords:
Concave disc plough, Tilt angle, Draft force, Von Mises stress, Pareto analysis, MATLAB, ANSYS, Drucker-Prager model, Wear, Loam soilAbstract
Ñ ABSTRACT Ñ
This study presents a comparative analytical and numerical investigation of the effect of tilt angle (15°–25°) on the performance of a concave disc plough (diameter = 660 mm, concavity depth = 100 mm) in three soil types: loam, heavy clay, and previously tilled soil. Three methodologies were employed: (1) an analytical model based on Hettiaratchi–Reece equations for draft force and stress estimation, (2) a 2D MATLAB simulation for von Mises stress distribution and Archard-based wear index calculation, and (3) a 3D finite element analysis in ANSYS using the Drucker-Prager soil model (c = 15 kPa, φ = 26°) and frictional contact (μ = 0.416). Results indicate that a 20° tilt angle yields the lowest Pareto-optimal index, with minimized draft force (28.04 kN in MATLAB, 28.1 kN in ANSYS), wear index (0.082), and specific draft (4.3 kN/m² in loam soil). ANSYS predicts a localized stress concentration at (X = 65.3 mm, Y = –179.3 mm)—the lower-front quadrant of the disc face—reaching 379.23 MPa, attributable to fine meshing and nonlinear analysis, yet remains structurally safe (σmax/σy = 31.6%). While MATLAB offers acceptable accuracy for preliminary design, ANSYS remains essential for local stress and wear assessment.