Improving the tracking and dynamic stability of a 4-DOF robotic arm using an Adaptive fuzzy PID controller based on a back-stepping methodology

Authors

  • ثائر احمد ابراهيم هندسة الأتمتة الصناعية - كلية الهندسة التقنية - جامعة طرطوس - سورية
  • فاطمة علي حبقه هندسة الأتمتة الصناعية - كلية الهندسة التقنية - جامعة طرطوس - سورية

Keywords:

Adaptive fuzzy controller – Backstepping control – 4-DOF robotic arm – Variable loads and External disturbances

Abstract

Current research focuses on improving tracking accuracy and enhancing the dynamic stability of the robotic arm under various conditions, including external disturbances and variable loads, by employing an adaptive fuzzy PID controller based on the Backstepping methodology. The desired controller is applied to an open-source 4-DOF robotic arm, where the proposed control unit has been tested at the joint level and compare it with a controller that combines a traditional P-PI sequential controller and a back-stepping methodology.

The simulation results in the Matlab/Simulink environment and the comparison show that the controller (which combines the back-stepping methodology and the P-PI sequential controller) is able to achieve a stable joint response under ideal conditions free from disturbances and loads, but its performance deteriorates significantly when external disturbances or variable loads are introduced, resulting in a loss of the ability to maintain accurate tracking. In contrast, the proposed controller (which combines the back-stepping methodology and the adaptive fuzzy PID controller) achieved the ability to quickly restore tracking and maintain system stability within safe limits when variable mass loads and external disturbances are introduced to the joints.

The comparison of results after loading shows that the adaptive fuzzy PID controller based on the Backstepping approach significantly improves tracking efficiency, reduces the mean absolute error, and adapted to load variations without loss of stability. The average performance improvement, compared to conventional controllers, ranges between 85% and 90% across the four joints under the same operating conditions. Moreover, the controller was able to handle load variations up to 60%, confirming its effectiveness in achieving rapid compensation and maintaining good dynamic stability without prolonged oscillations.

Downloads

Published

2026-10-29